How to Make a Simple Timer Circuit Using IC 555

A timer is a device which produces a delay period after which an external connected electrical load is triggered. The produced time delay is normally adjustable and the user has the freedom to set the time period as desired. There are many ways of making simple timer circuits using different ICs and discrete components; here we discuss one such circuit using the ubiquitous IC 555.

The IC 555 is a pretty common electronic part among the electronic enthusiasts and is also very popular due to the involved simple configurations and low component count.

The two popular multivibrator modes of operation that’s associated with this IC are the astable mode, and the monostable mode. Both of these are useful configurations and have plenty of different applications.

For the present design we incorporate the second mode of operation, which is the monostable mode.

In this mode of operation the IC is configured to receive a trigger externally, so that it’s output changes state, meaning if with reference to the ground if the output of the IC is zero, then it would become positive as soon as the trigger (momentary) is received at its input terminal.

This change in its output is sustained for a certain period if time, depending upon the external time determining components. Normally the time determining components are in the form of a resistor and a capacitor which together determine or fix the time period for which the IC output would hold its “high” position.

By changing either the value of the capacitor or the resistor, the timing can be altered as desired. The above time fixing components are termed as the RC component.

The figure shows a very straightforward design where the IC 555 forms the central controlling part of the circuit. As discussed in the above section, the IC is in its standard monostable mode.

Pin #2 receives the external timing trigger from a push-to-ON switch. Once this switch is pushed, the circuit pulls its output to a positive potential   and holds it until the predetermined time delay lapses.

The entire circuit can be built over a small piece of general PCB and housed inside a neat looking plastic enclosure along with the battery.

The output may be ideally connected to a buzzer for receiving the warning alarm after the set time lapses.

Parts List

R1, R4 = 4K7,

R2 = 10K,

R3 = 1M pot,

C1 = 0.47uF,

C2 = 1000uF/25V,

C3 = 0.01uF,

IC1 = 555,

Bz1 = Piezo Buzzer,

Push Button = push to ON switch

A circuit design requested by Mr.Bourgeoisie:

Tweet