Simple LED Bike Light

On my mountain bike I always used to have one of those well-known flashing LED lights from the high street shop. These often gave me trouble with flat batteries and lights that fell off. As an electronics student I thought: “this can be done better”. First I bought another front wheel, one which has a dynamo already built in the hub. This supplied a nice sine wave of 30 Vpp (at no load). 

With this knowledge I designed a simple power supply. The transistors that are used are type BD911.These are a bit of an over-kill, but there were plenty of these at my school, so that is why I used them. Something a little smaller will also work. The power supply is connected to an astable multi-vibrator. This alternately drives the front light and the rear light. The frequency is determined by the RC time-constant of R3 and C3, and R2 and C4. This time can be calculated with the formula: t = R3×C3 = 20×103×10×10-6 = 0.2 s You can use a 22k (common value) for R2 and R3, that doesn’t make much difference. On a small piece of prototyping board are six LEDs with a voltage dropping resistor in series with each pair of LEDs.

LED Bike Light Circuit Diagram:

Light Circuit Diagram

Such a PCB is used for both the front and the rear of the bike. Of course, you use white LEDs for the front and red ones for the rear. The PCB with the main circuit is mounted under the seat, where it is safe and has been working for more than a year now. There are a few things I would change for the next revision. An on/off switch would be nice. And if the whole circuit was built with SMD parts it could be mounted near the front light. This would also be more convenient when routing the wiring. Now the cable from the dynamo goes all the way to the seat and from there to the front and rear lights.


Related Posts :

  • 8 Stage LED VU MeterThe circuit below uses two quad voltage comparators (LM339) to illuminate a series of 8 LEDs indicating volume level. Each of the 8 comparat… Read More...
  • Simple Strip LED LampStrip LEDs are available in different colours powered by direct current (DC) source. These LEDs  are available as surface mount devices… Read More...
  • Simple LED Bike LightOn my mountain bike I always used to have one of those well-known flashing LED lights from the high street shop. These often gave me trouble… Read More...
  • Multi-Color LEDHow many different conditions do you reckon may be signalled with just one LED? Two, maybe three? Using this simple circuit, a lot more! Adm… Read More...
  • Regulated 24 Watt Broad Spectrum LED This project involves constructing an energy efficient broad spectrum LED lamp system. The lamp is useful for indoor reflective room lightin… Read More...

0 Response to "Simple LED Bike Light"

Posting Komentar